|




The latest
development at Performance Jet in 2003 was the new High Output Intake
Loader. Jim has been working with this design for the last few
years and the loaders are now ready.
AWESOME design and
workmanship make this loader the best looking and best performing loader
on the market today! Three different styles to meet your high
performance needs!
Jim is so sure of the
performance output of this loader that he guarantees that it will pick
up mid range pull and top speed over the loader you are now
running!! We have done the testing on GPS!!
This loader picks up 5 to
7 mph over stock grates and 1 to 2 mph over every after market loader
that we have tested to date. If this loader does not make your
boat run faster, then send it back to PERFORMANCE JET for a full
refund. (less shipping.)
|
PN# PJ
10-01 FCB
This loader has a longer center
blocker. I have discontinued this
model for now but will consider building
a new batch in the future.
|
|
PN#
PJ 10-02 HCB
This is a great loader that has a good
hole shot and increases mid range pull to
top end on any jet boat. The
center blocker helps create lift when
your focus is top end speed. You
will really notice an increase in
mid-range pull that pulls hard all the
way to the top.
|
|
PN# PJ 10-03 OPEN
This is a great all-around top loader
that does not have a center
blocker. This loader will work
great in all applications incorporating
a great hole shot, mid-range pull, and
top end speed. For high HP
applications or heavier boats where a
blocker may induce a slight cavitation
on the hole shot, this loader is your
choice.
|



|
The
White Lightning top loader built by
Performance Jet is the only loader on
the market that provides a 5th mounting
point for severe duty
applications. Shown here in the
photo, you can see the 5th mounting
point located at the rear end of the
loader. The jet drive has to be
removed from the intake adapter to set
this up. Mark and drill the
adapter and tap for a 1/4 x 20 tapered
head fastener; a washer may be needed
for a shim on some set ups. This
will lock down the loader and eliminate
any possibility of vibration or
movement. |
 |
Due to the nature of
the marine industry, prices are subject to change.
|